Search the Community
Showing results for tags 'sifting table'.
-
Hi hope this is the right place in the forum to ask this, I have a limestone quarry that I hunt in using a sifting table. And it’s that type of sand that when wet just clogs up the table every use, do anyone have any tips to get past this? I’m usually only able to hunt in the summer when the sand is dry but I just can’t wait 😅 below is the sifting table I use, inspired by someone in the forum.
- 5 replies
-
- sifting table
- sandy
-
(and 1 more)
Tagged with:
-
Sharktooth Hill Trip Report Part 1 – building the sifting table Hi everyone, After my first trip to Sharktooth Hill in June, I was hooked. I immediately started making plans to return and, this time I’d come better prepared. This forum has provided an amazing source of ideas and helpful people and inspired me to build a sifting table for my next trip to STH. A huge thanks to those who have helped me by answering questions, providing pictures and ideas, and helping me troubleshoot. I gathered as much info as I could and then tried to combine all the best ideas into one contraption to fit my needs. I’m excited to try this beast out next week! It’s big! The screen is 37.5” x 21” and the table stands about 4 feet tall but I will lower it if the height proves too high to load easily. I don’t want to sacrifice “wobbly-ness” though, because I’m hoping that’s going to do a lot of the sifting work for me. Plus, my son and I are 6’5” and 6’4” so a tall table should be ok. I used SCH 40 PVC and the 2 rectangular bases are glued while the 4 legs are removable to allow for compact storage/transport. In limited testing everything stayed together but I’ll bring some PVC glue with me in case I need to solidify it in the field. I'll also bring my PVC cutter for “disassembly” for the way home if need be. The bottom tier is ¼” mesh and has 6 “T” brackets to make sure it stays on top of the PVC frame. I bolted on a handle to allow it to be shaken one- or two-handed. There are no pointy parts on the inside (trying to avoid bleeding as much as I did on my last visit to STH). The top tier is ½” mesh and sits inside the bottom tier. Corner braces in the bottom tier (see above) allow the upper tier to sit low enough that it won’t dislodge but high enough that the contents can move freely across the bottom mesh. Initially I was disappointed that the large size and my inability to “tighten” that mesh caused it to sag noticeably once it was loaded up with soil. I remedied this with the addition of an adjustable bracket along the midpoint. But then when I put the top tier inside the bottom tier I realized I’d created a teeter-totter (doh!) and had to chisel out a groove on each side to allow it to fit in there. I’m very excited to go give it a try and I hope you all find this pre-trip report interesting. I’m happy to answer any questions and/or accept suggestions for improvement. And thanks again to all the helpful people on this forum whose previous pictures, design notes, and conversations encouraged me to attempt this (and make this post). I’ll send a follow up trip report after I get home. Cheers!
- 17 replies
-
- 2
-
- bakersfield
- round mountain silt
- (and 5 more)