Search the Community

About a month ago I went to Penn with two fossil buddies and they both found prone greenops. Sadly I did not find one. However both of these greenops were split between the positive and negative and probably were missing some skin as the material was quite flaky. For one of my friends this was his first ever find of a prone greenops. Prone greenops that are nicely laid out are a very rare find in the Windom shale. Most of the ones I have found from there or others that I have prepped for people are fully, partially enrolled or distorted. So to my fossil buddy this was a bit of a special find. We wrapped up the two pieces in tin foil in the field and I agreed to take it with me and prep it for him. Well zoom ahead a month in time and I am going out with him last week to collect and he asks how is his greenops coming, whereby I realize that I have not only not started it ,but in my senility had forgotten I had it and had no clue where it was. Well when I got home it turns out that I had never unpacked the bucket of fossils from that trip and low and behold his fossil was packed just as we had left it. A careful look at both parts under the scope confirmed my opinion that the bug was in pretty rough shape , but a prone greenops, not to mention perhaps his first ever prone warranted we attempt to bring it back to life. Unfortunately I did not take any pics until a ways into the prep but here is what I did to start. 1. Washed the mud off both plates scrubbing with a tooth brush 2. Squared up what would become the fossil plate with the diamond gas saw 3. Cut out as small as possible a square from the top piece of the matrix that contained the top part of the greenops using my 7 inch tile saw with diamond blade 4. On a belt sander using aluminum oxide 120 grit thinned the top piece as much as safely possible to help minimize my prep time later. 5. Using super thin cyanoacrylate glue reattached the top portion to the main slab clamping tightly with a c-clamp. Asusual all prep was done under a zoom scope at 10x to 20x magnification using a Comco abrasion unit and in this case a German Pferd MST 31 scribe exclusively.. Not a lot of scribing was done other than to outline the bug as the skin was not in great shape. Abrasion was pretty much done with a .18 and .10 nozzle using 40 micron previously used dolomite at 30 PSI. Here is the bug after about an our of prepping . I have outlined in red where you can still see the outline of the section that was glued down. A lot of people do not realize that many of the fantastic trilobites you see on the market have actually been glued back together because the splits are often through the bug. I once did a Moroccan trilobite that was in 7 pieces when I received it Here is the bug after another 40 minutes Took some pictures of the prep but frankly they ended up too blurry to use so here is the prep after abrasion is complete and after I have repaired a lot of the parts that broke of in the split. I tend to use a white repair material and always take a picture to let the owner know what has been repaired Here is the bug after coloration applied . The repairs were allowed to cure overnight before coloration and a bit of extra carving to clean up spots.Just waiting for me to do a final cleanup tomorrow after everything has cured a bit more. A long way from being the worlds most pristine or perfect bug but I am relatively pleased that we were able to breath some new life into an ailing bug. Totally prep time about 3 1/2 hours over 4 days. I suspect the owner will be pleased with the result. I have seen people toss bugs in the field that were in this type of shape. For those of you who just need to know the bug is 27mm x 18 mm A slightly different view