Thoughts on this Anzu claw?

[W. Harvey]

Is the ID on this claw correct? It's labeled as a foot claw belonging to Anzu wyliei.

 

Edit: It's about 2" long and is from the Hell Creek Formation, Montana.

 

Edited September 6, 2020 by W. Harvey

[Troodon]

Has the morphology of one but do you have a locality to support the provenance lrovided

[W. Harvey]

55 minutes ago, Troodon said:

Has the morphology of one but do you have a locality to support the provenance lrovided

All I know beyond what I listed above is that it was found in Powder River County. Does it look like a good quality claw to you? I know dinosaur claws are one of your focuses.

[musicnfossils]

Looks a bit worn on the tip but not a bad claw at all. 

[Dracorex_hogwartsia]

Years ago, this was the type of claw that would have been labeled and sold as a T. rex hand claw.

[Troodon]

3 hours ago, W. Harvey said:

All I know beyond what I listed above is that it was found in Powder River County. Does it look like a good quality claw to you? I know dinosaur claws are one of your focuses.

That's what is always needed, county, from material from Montana.  Yes its a juvie claw looks fine.  No red flags just a little worn.

50 minutes ago, Dracorex_hogwartsia said:

Years ago, this was the type of claw that would have been labeled and sold as a T. rex hand claw.

Yes.  Quite a few years ago the BHI was selling 4" replicas of these as Trex hand claws.  I bought one, had a engraved plack.