Kane Posted October 17, 2018 Share Posted October 17, 2018 UPDATE: Consolidated all my loose preparation threads into one topic. Four hours so far into this big bug, and maybe another two to go. Found at Penn Dixie this past weekend, the visible area measures 6 cm. With the pygidium, it likely measured about 8+ cm. Judging by its size and pustular sculpture, this was likely a long-lived specimen prior to burial. This is how it looked fresh in the field: 1 ...How to Philosophize with a Hammer Link to comment Share on other sites More sharing options...
Kane Posted October 17, 2018 Author Share Posted October 17, 2018 There are a few challenges with this one: 1. It dips or lists to the left. 2. There was dense matrix on the left and back that was time consuming to remove, using a terracing approach. 3. There is distortion on that left side, displacing the eye and left genal in general. 4. Compaction damage to the glabella. This is after 1.5 hours: 3 1 ...How to Philosophize with a Hammer Link to comment Share on other sites More sharing options...
Ptychodus04 Posted October 17, 2018 Share Posted October 17, 2018 Looking good @Kane! You’ve become quite skilled a prepper very quickly. Regards, Kris Global Paleo Services, LLC https://globalpaleoservices.com http://instagram.com/globalpaleoservices http://instagram.com/kris.howe Link to comment Share on other sites More sharing options...
Kane Posted October 17, 2018 Author Share Posted October 17, 2018 After another 2.5 hours, it is starting to look much better. As an added surprise, a smaller roller was discovered beneath it. I figure another 2 hours will complete this bug, and maybe another hour or so for the small roller to make this a neat association. I'm using an ARO clone with factory tip (not ideal), a Paasche using straight dolomite at varying pressures, and without the benefit of smaller dispensing needles. I might risk bringing the left side a bit lower, but it's tough to say what shape that side is in (yet). I expect to give it another go this Friday when I have time. 6 3 ...How to Philosophize with a Hammer Link to comment Share on other sites More sharing options...
Kane Posted October 17, 2018 Author Share Posted October 17, 2018 Thanks, @Ptychodus04! Still finding my way around. Times like these (with excess matrix) make me pine for a CP9361! I put it on my xmas wish-list, so fingers crossed. I may have to revise my above estimate for some much-needed matrix sculpting to smooth out the "little cliffs" and ugly scribe marks. Maybe another hour to the total! ...How to Philosophize with a Hammer Link to comment Share on other sites More sharing options...
Fossildude19 Posted October 18, 2018 Share Posted October 18, 2018 Great job so far, Kane! These guys can be crushed pretty badly on one side - kind of how your's looks. Can't wait to see the finished product. Tim - VETERAN SHALE SPLITTER VFOTM --- APRIL - 2015 __________________________________________________ "In every walk with nature one receives far more than he seeks." John Muir ~ ~ ~ ~ ><))))( *> About Me Link to comment Share on other sites More sharing options...
Ptychodus04 Posted October 18, 2018 Share Posted October 18, 2018 @Kane Paleo tools sells a longer stylus that fits the Aro and its clones. Well worth the $70 or so for it. I use the 2.5” length. 2 Regards, Kris Global Paleo Services, LLC https://globalpaleoservices.com http://instagram.com/globalpaleoservices http://instagram.com/kris.howe Link to comment Share on other sites More sharing options...
piranha Posted October 18, 2018 Share Posted October 18, 2018 1 hour ago, Kane said: ...the visible area measures 6 cm. With the pygidium, it likely measured about 8+ cm... Don't shoot the messenger... I see ±6 cm ... Link to comment Share on other sites More sharing options...
Kane Posted October 18, 2018 Author Share Posted October 18, 2018 31 minutes ago, piranha said: Don't shoot the messenger... I see ±6 cm ... That first photo is a bit misleading as the measuring square is resting on the head of the hammer. I’m measuring with the curvature on the now more exposed specimen (using a string and ruler ). He certainly isn’t the runt of the litter. ...How to Philosophize with a Hammer Link to comment Share on other sites More sharing options...
ynot Posted October 18, 2018 Share Posted October 18, 2018 Looks real good Kane. Darwin said: " Man sprang from monkeys." Will Rogers said: " Some of them didn't spring far enough." My Fossil collection - My Mineral collection My favorite thread on TFF. Link to comment Share on other sites More sharing options...
KimTexan Posted October 18, 2018 Share Posted October 18, 2018 Look very cool. Nice bug. Link to comment Share on other sites More sharing options...
Kane Posted October 19, 2018 Author Share Posted October 19, 2018 Update on the prep. Basically done. Left side is quite crushed, so it wasn't worth the risk to push it too much farther. But the left eye is finally exposed, and the left gena is tucked/folded underneath some very fractured areas. Most of what appears between the segments is just dolomite dust with the exception of the lower left of the thorax which has some very sticky pyritization. Doing much more without the benefit of dispensing needles is really not advisable for this one. Just a few more touch-ups to go. This one has taken a ridiculous amount of time (about 10 hours). 5 3 ...How to Philosophize with a Hammer Link to comment Share on other sites More sharing options...
Kane Posted October 19, 2018 Author Share Posted October 19, 2018 But there is more to this rock for prep: an average sized roller below the primary trilobite: 1 ...How to Philosophize with a Hammer Link to comment Share on other sites More sharing options...
Kane Posted October 19, 2018 Author Share Posted October 19, 2018 And while I had the compressor going, just a very quick, light blast to what will be a new challenge for me. A notoriously thin-skinned Greenops widderensis, enrolled with flying genal spines. It is important that I learn through experience how to prep these. 2 1 ...How to Philosophize with a Hammer Link to comment Share on other sites More sharing options...
Ptychodus04 Posted October 19, 2018 Share Posted October 19, 2018 Just now, Kane said: A notoriously thin-skinned Greenops widderensis, enrolled with flying genal spines. It is important that I learn through experience how to prep these. I hate thin skinned trilobites; they get their feelings hurt way too easily. 3 Regards, Kris Global Paleo Services, LLC https://globalpaleoservices.com http://instagram.com/globalpaleoservices http://instagram.com/kris.howe Link to comment Share on other sites More sharing options...
Kane Posted October 19, 2018 Author Share Posted October 19, 2018 Just now, Ptychodus04 said: I hate thin skinned trilobites; they get their feelings hurt way too easily. ...How to Philosophize with a Hammer Link to comment Share on other sites More sharing options...
Walt Posted October 19, 2018 Share Posted October 19, 2018 wah......... Everything is generated through your own will power ~ Ray Bradbury Link to comment Share on other sites More sharing options...
Paciphacops Posted October 19, 2018 Share Posted October 19, 2018 On 10/17/2018 at 7:06 PM, Ptychodus04 said: Paleo tools sells a longer stylus that fits the Aro and its clones. Well worth the $70 or so for it. I use the 2.5” length. Please be aware that the longer Paleo tools stylus is thicker and requires their modified bushing, which now costs $110. All Air Products sells a replacement stylus that is about 0.5 inches longer than the factory Aro stylus, that is a direct fit in any Aro clone. I have one and the extra 0.5" makes a big difference. It is not listed on the website, so you have to call. I think mine cost around $25-30. 2 "Don't force it, just use a bigger hammer" Link to comment Share on other sites More sharing options...
Kane Posted October 19, 2018 Author Share Posted October 19, 2018 And this little prone took me just over an hour. Before and after: 7 4 ...How to Philosophize with a Hammer Link to comment Share on other sites More sharing options...
Bobby Rico Posted October 19, 2018 Share Posted October 19, 2018 Two different bugs. Are you trying to dupe us? very nice work indeed Kane congratulations. 1 Link to comment Share on other sites More sharing options...
Kane Posted October 19, 2018 Author Share Posted October 19, 2018 Thanks, Bobby. Looking at them side by side, they do look like night and day! 3 ...How to Philosophize with a Hammer Link to comment Share on other sites More sharing options...
Bobby Rico Posted October 19, 2018 Share Posted October 19, 2018 24 minutes ago, Kane said: Thanks, Bobby. Looking at them side by side, they do look like night and day! That just goes to show what the right amount of good prep work does to enhances a specimen. Link to comment Share on other sites More sharing options...
Fossildude19 Posted October 19, 2018 Share Posted October 19, 2018 Sweet! Getting pretty good there, K-man. Well done, sir. 3 1 Tim - VETERAN SHALE SPLITTER VFOTM --- APRIL - 2015 __________________________________________________ "In every walk with nature one receives far more than he seeks." John Muir ~ ~ ~ ~ ><))))( *> About Me Link to comment Share on other sites More sharing options...
Kane Posted October 19, 2018 Author Share Posted October 19, 2018 Thanks, Tim! And thanks for the photo stitch (saved to the device!). ...How to Philosophize with a Hammer Link to comment Share on other sites More sharing options...
ynot Posted October 19, 2018 Share Posted October 19, 2018 Looks really good! Darwin said: " Man sprang from monkeys." Will Rogers said: " Some of them didn't spring far enough." My Fossil collection - My Mineral collection My favorite thread on TFF. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now